Publications dans lesquelles il/elle collabore avec Jacinto Santamaría Peña (12)

2024

  1. Sustainability of Pumped Hydropower for Short-Term Storage of Wind Farm Electricity

    Lecture Notes in Mechanical Engineering

2023

  1. 3D Printing of 3D Terrain Maps to Improve the Teaching–Learning Processes of Terrain Modeling and Civil Engineering Works

    Lecture Notes in Mechanical Engineering

  2. Detection of high erosion risk areas and their incorporation into environmental impact assessment

    Soil and Water Research, Vol. 18, Núm. 2, pp. 102-115

  3. Hydrogen Sustainability for Short Term Storage of Wind Farm Electricity

    Lecture Notes in Mechanical Engineering

  4. Introducing the BIM Environment in Higher Education: Industrial Building Modelling Exercise-Type in Autodesk© REVIT and Its Transfer to the Classroom in Four Pills

    Lecture Notes in Mechanical Engineering

2022

  1. Environmental Efficiency Indices in the Public Hospital Sector: A Proposal

    Applied Sciences (Switzerland), Vol. 12, Núm. 16

  2. Technical Inspections of Agricultural Machinery and Their Influence on Environmental Impact

    Agronomy, Vol. 12, Núm. 4

  3. The Digital Simulation of the Visual Impact of Power Lines as a Tool to Optimize the Design of the Power Line Network

    Advances in Design Engineering II: Proceedings of the XXX International Congress INGEGRAF, 24-25 June, 2021, Valencia, Spain

  4. The Digital Simulation of the Visual Impact of Power Lines as a Tool to Optimize the Design of the Power Line Network

    Lecture Notes in Mechanical Engineering

2021

  1. Digital eco-design and life cycle assessment—key elements in a circular economy: A case study of a conventional desk

    Applied Sciences (Switzerland), Vol. 11, Núm. 21

2010

  1. Software applicationas for territory visualization with VRLM-Web3D and Graphic Libraries

    Multimedia (InTech)

  2. Virtual representation of terrain through the web with VRML-Web3D and graphic libraries

    International Journal on Interactive Design and Manufacturing, Vol. 4, Núm. 2, pp. 125-136