Novel method for setting the mechanical and topographic properties of strips within one process step [Neues Verfahren zur unabhängigen Einstellung der mechanischen und topografischen Bandeigenschaften]
- Diegelmann, V. 5
- Zwickel, G. 1
- Ullrich, M. 1
- Gouveia, H. 3
- Weirauch, U. 4
- Boguslawsky, K. 4
- Espinoza, P. 2
- 1 Bilstein GmbH and Co KG, Hagen, Germany
-
2
Universidad de La Rioja
info
- 3 Instituto de Soldadura e Qualidade, Porto Salvo, Portugal
- 4 Leiter Bandbehandlungsanlagen, Andritz-Sundwig GmbH, Hemer, Germany
- 5 Projektleiter System-und Verfahrensentwicklung Umformtechnik, VDEh-Betriebsforschungsinstitut GmbH, Düsseldorf, Germany
ISSN: 0340-4803
Année de publication: 2013
Volumen: 133
Número: 11
Pages: 215-222
Type: Article
beta Ver similares en nube de resultadosD'autres publications dans: Stahl und Eisen
Résumé
Main objective was the development of an innovative strip finishing procedure by combining tension levelling and skin pass rolling into one production step and thus to shorten the process chain. It could be proved that the mechanical characteristics of strip material mainly adjusted during the skin pass rolling process are possible to be achieved as well during a pure tension levelling process by variation of applied tension and bending load. The realisation of the desired surface texture requires an additional superposed deformation under pressure introduced simultaneously in those strip sections where the yield strength of the material already is met by the applied tension-bending procedure. Using the new facility it will be possible to adjust material mechanical and surface roughness properties independently. Thus the new technique fundamentally contributes to the common development to require steel grades with highest surface quality and simultaneous highest available deformation resources.