Residual stresses with time-independent cyclic plasticity in finite element analysis of welded joints

Resumen

Due to the intense concentration of heat in a reduced area when Gas Metal Arc Welding (GMAW) is used to join mechanical components, the regions near the weld bead are subjected to severe thermal cycles. Firstly, the region close to the weld bead that is heated tends to be in compression and, when it cools, tends to be in tension. According to Pilipenko, the material is exposed to elastic compression and, then, reaching the yield limit, undergoes plastic deformation with the appearance of residual stresses followed by elastic-plastic unloading. This could be considered as a strain-stress cycle. This paper applies plastic-strain-range memorization based on time-independent cyclic plasticity theory for butt joints with single V-groove Finite Element (FE) models that were manufactured by GMAW. The theory combines both the isotropic hardening and the nonlinear kinematic hardening rule (Chaboche model) to reproduce the behavior of cyclic plasticity and thus to obtain the residual stresses in welded joint FE models. As a practical example, the proposed theory is validated by three welded joint specimens that were manufactured with different input parameters of speed, voltage, and current. An agreement between the residual stresses obtained by the FE model proposed and those obtained experimentally by the hole drilling method at different depths demonstrates that the proposed theory could be valid for modelling the residual stresses in welded joints when cyclic plasticity is considered over the range of speed, voltage, and current studied. © 2017 by the authors. Licensee MDPI, Basel, Switzerland.